Nov 15 How to fix paladin dps Just make holy wrath & exorcism work on all types of enemy but not affect player characters. It's an easy fix that will make pally dps better in pve but stay the same as they were in vanilla in pvp. Put this thing into a deep ret talent so it will require people to spec deep in ret to be able to dps. A good spot is add it with two-hand weapon specialization making it so that by putting talents into it all hostile aside from players and undeads(since they are already affected by the default version) to be affected by the dmg and effects of the spells effectiveness by 33%/66%/100%. I doubt they would even do this so im just throwing out ideas since too many of you dont actually read the forum and only read the OP here you go to explain a bit of my reasoning because this change wont make ret stronger than pure dps; clearly most of you people didnt play vanilla nor know anything about naxx. ...Toushin260 Nov 15
A demo of the game was available at BlizzCon 2018, and was downloadable on home computers for anyone who purchased a BlizzCon ticket or virtual ticket. The servers became available when Opening Ceremony started at BlizzCon 2018 and was set to end on November 8, but was extended until November 12.[4] Players started at level 15, and the only available zones were Westfall and the Barrens.[5] It was based on patch 1.13.0, essentially patch 1.12.0 ported to a modern infrastructure. The first day of the demo, there was a playtime limit of a cumulative 60 minutes with a cooldown of 90 minutes, applied through the BlizzCon Exhaustion debuff.[6] The debuff was removed on the second day of BlizzCon 2018.[7]
Some quests in my guide are marked as "SKIP" and colored in red.  These quests are simply either too hard to solo or not worth the XP/time and are skipped.  My guide will only list SKIPPED quests if the quest is a direct follow up after completing a quest, not one that you have to click the NPC again to get it.  If you hover over the skipped quests, it will give info on why it is skipped in the guide (unless that info is already listed directly in the guide text).

 ":"  -  Any time a step ends in a ":" instead of a "." means that the next step is part of the current step you are on.  This generally means the next step should be done while working on the current step.  This means every "start working on" or "continue working on" will end in a ":".  But this is used with other occasions as well, so keep this in mind.
×